|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 20th 06, 03:49 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Safety wiring oil filters?
A question for those flying auto converisons - how do you secure the
oil filter? Aviation oil filters have safety wire tabs. FRAM HP filter, which for various reason are what I need to use on my VW based conversion, no got. Oil filters typically go on finger tight. Losing your oil filter could ruin your WHOLE day. Anybody got any ideas how to secure this bad thing? I've thought about forming a little "hat" out of a stainless steel mixing bowl that would at least keep it from falling off. And silver soldering on some tabs... Any ideas? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
| Air Force One Had to Intercept Some Inadvertent Flyers / How? | Rick Umali | Piloting | 29 | February 15th 06 04:40 AM |
| Nearly had my life terminated today | Michelle P | Piloting | 11 | September 3rd 05 02:37 AM |
| Parachute fails to save SR-22 | Capt.Doug | Piloting | 72 | February 10th 05 05:14 AM |
| USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |
Threaded Mode