|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 23rd 06, 05:41 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aluminum welding
I've decided that I'm going to go ahead and try my hand at gas welding
aluminum. I have the TinMan's video. I have the flux. And I have lots of experience welding...steel. The one question I have is cleaning the flux. The video has the TinMan welding and then cleaning coupons with a damp rag. But how would you clean the inside of a closed fuel tank? -- This is by far the hardest lesson about freedom. It goes against instinct, and morality, to just sit back and watch people make mistakes. We want to help them, which means control them and their decisions, but in doing so we actually hurt them (and ourselves)." 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 05:55 AM |
Threaded Mode