![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I've been googling my heart out for some fuel burn numbers for the
Piaggio Avanti. Could someone in the know give me even an average ballpark number in pounds per hour? |
#2
|
|||
|
|||
![]()
600
"buttman" wrote in message oups.com... | I've been googling my heart out for some fuel burn numbers for the | Piaggio Avanti. Could someone in the know give me even an average | ballpark number in pounds per hour? | |
#3
|
|||
|
|||
![]()
A little research on the Piaggio site gives a specific range
number of .84 pounds per NM and high speed cruise is 398 knots, this is 335 pph at cruise, but total fuel flow will be higher during climb and at lower altitudes, I'll stick with a figure of 600 ponds the first hour and 400 pounds the second hour at high speed. "buttman" wrote in message oups.com... | I've been googling my heart out for some fuel burn numbers for the | Piaggio Avanti. Could someone in the know give me even an average | ballpark number in pounds per hour? | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time, running out of fuel and fuel gauges | Dylan Smith | Piloting | 29 | February 3rd 08 07:04 PM |
I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 03:55 AM |
Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 02:24 PM |
Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 11:35 AM |
Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 46 | January 15th 05 10:20 PM |