|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 8th 06, 11:44 AM
posted to rec.aviation.restoration
|
|||
|
|||
Removing a finger strap
Assume a finger strap around a tube and you wish to save the tube.
How do you 'unweld'/remove the finger strap? Can't chuck the piece. so I'm thinking grinding with an angle grinder is the secret. Anyone got thoughts? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crouch Strap story | Ed Byars | Soaring | 43 | September 23rd 13 06:43 PM |
| Forming finger straps. | Mike | Restoration | 7 | April 16th 06 04:53 AM |
| Removing water repelent from fiberglass lay-up? | Roger | Home Built | 2 | December 3rd 04 12:15 AM |
| Removing a Major Alteration. | JDupre5762 | Owning | 5 | March 19th 04 07:25 PM |
| F-14 squadrons removing refueling cover plate? | dave999 | Military Aviation | 7 | August 6th 03 10:45 AM |
Threaded Mode