![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
"It would appear that Mike Palmer is correct, and that I owe FastGlasAir an
apology. It was NOT FastGlasAir that had anything to do with Palmer's attitude towards California regulations regarding concealed weapons or implements, and for that I do apologize." I ACCEPT YOUR APOLOGY, however, I would ask that in the future that you and others in this group refrain from the personal attacks and insults when you believe someone is out of line. I don't think its appropriate to be Judge Jury and Executioner. You guys acted like a lynch mob. "My disagreement with Mr. Palmer will continue if he chooses to drag it on. I'm glad Mr. Daley found your chest target amusing. Then again, to bring Destruction Daley onto your side is not exactly sleeping with the angels, is it?" "FastGlasAir, I may or may not disagree with your aerodynamics, but please accept my apology for the misidentification. It was all too similar and coincidental, and I should have dug deeper." I don't claim to be a know it all or anything else regarding aerodynamics. However I did discuss my prop choice with a significant number of knowledgeable people prior to my decision. I knew I might give up a little on the top end but I wanted to look at the big picture of harnessing all that HP. I do plan to do some aerobatics also. I do have an inverted fuel and oil system as well as an oil accumulator to maintain oil pressure during knife edge flight, since I do not have a counterweighted prop. Dan (FastGlasair) |
#2
|
|||
|
|||
![]()
Seems you gon' have one hell of an airplane. I'd probably take that sucker to
Reno and race it if I were you. I can put you in touch with a person that has raced Glassasses at Reno for some years. Jim (Fastglasair) shared these priceless pearls of wisdom: -I wanted to look at the big picture of harnessing all that HP. I do plan to do -some aerobatics also. I do have an inverted fuel and oil system as well as an -oil accumulator to maintain oil pressure during knife edge flight, since I do -not have a counterweighted prop. - -Dan (FastGlasair) - - Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | January 1st 05 07:29 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | December 1st 04 06:28 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | April 1st 04 08:27 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | February 1st 04 07:27 AM |
Fastglasair's plane | Fastglasair | Home Built | 12 | July 18th 03 03:17 PM |