|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 24th 06, 11:28 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Fiberglass seperation
Ok, I've made a few pieces to try out using 1/4" foam and fiberglass on
both sides. When I cut the pieces to shape with my band saw, small strips (1/4" or so) seem to want to seperate. Is this common or did I mix the epoxy wrong? The big parts are staying together, the fiberglass itself is staying to gether but the small parts are seperating from the foam. Lou 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fiberglass vs. Fabric | Lou | Home Built | 35 | July 6th 06 06:08 PM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 3rd 04 12:15 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 03:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 04:52 AM |
| Fiberglass Tip Tanks Question | Jay Honeck | Owning | 7 | September 26th 03 05:23 AM |
Threaded Mode