|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 22nd 06, 04:22 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Connecting hoses to pitot/static tubes
What is the best way to secure plastic tubing to aluminum pitot tubes.
The plastic hose will slide over the aluminum tube, though it requires quite a bit of push to get more than 1/2". Would a couple of spring clamps work, or is something more significant called for? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: NON FUNCTIONAL VT-4-C and VT-25 vacuum tubes, other gear for B-17 setup | Juan Jimenez | General Aviation | 7 | September 19th 06 11:20 PM |
| Wanted: NON FUNCTIONAL VT-4-C and VT-25 vacuum tubes, other gear for B-17 setup | Juan Jimenez | Aviation Marketplace | 7 | September 19th 06 11:20 PM |
| Proposed AD ECi connecting rods | Jim Burns | Owning | 8 | October 8th 05 05:27 PM |
| Seeking US Source for Main Wheel Tubes | Chris OCallaghan | Soaring | 7 | August 28th 04 04:46 PM |
| Rockets used in al-Rashid hotel match "aluminum tubes" rockets | Robb McLeod | Military Aviation | 7 | October 28th 03 08:49 AM |
Threaded Mode