|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 14th 06, 01:05 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Lye as an aluminum cleaner?
I've taken my aileron apart and notice corrosion on the thin aluminum
parts, so I'm reading around about cleaning prior to alodining. I've taken a stainless steel brush to the surface and removed most of the corrosion, but it's really a PITA. Someone suggested using lye as a cleaner. Anyone have any experience using supermarket lye in that role? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Corrosion at Aluminum/Steel Junction | Front Office | Home Built | 17 | June 26th 06 02:12 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 03:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 06:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 04:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 07:24 AM |
Threaded Mode