|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 12th 07, 11:08 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Stainless steel exhaust
Aircraft Spruce has an exhaust for Pitts, AcroSport, etc. Has anyone
used it? If so, did it fit and do you recomend. It bolts to the engine and has ball joints for 2 straight pipes. I plan to use on an AcroSport with AEIO-320. Headwind 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stainless lines and fittings, free for the taking | Richard Riley | Home Built | 4 | May 7th 06 04:46 PM |
| nicopress sleeve for stainless steel cable | ls | Home Built | 3 | December 6th 05 05:09 PM |
| Working Stainless Steel | Bob Babcock | Home Built | 7 | February 14th 04 05:12 PM |
| structural stainless steel tank screws needed for PA-32-300 | Dave | Owning | 11 | October 1st 03 11:14 PM |
| 37 degree flare, 1/8" stainless | Richard Riley | Home Built | 8 | August 29th 03 05:21 AM |
Threaded Mode