|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 31st 03, 04:01 PM
|
|||
|
|||
Tool Question???
I'm looking for an adapter with a 3/8--24 thread on one end and a 1/4--28
thread on the other. This would allow me to use a standard Jacobs chuck on my right angle drill. Surely some one must sell such a device. Since I retired, I no longer have easy access to a lathe so I must now go tool hunting. G Thanks much Paul NC2273H 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tailwheel question | Steve B | Aerobatics | 4 | January 30th 04 03:35 AM |
| Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
| question: differences between epoxy layup and plaster | Morgans | Home Built | 3 | August 6th 03 04:46 AM |
| Flap design question | Chris W | Home Built | 1 | August 4th 03 02:50 PM |
| question on intercoms for my new homebuilt | w b evans | Home Built | 1 | July 23rd 03 12:57 AM |
Threaded Mode