|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 19th 07, 10:47 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welding question: joining an inner sleeve
Please see the sketch at http://members.cox.net/mhorowit/cluster/
Using Oxyacetylene, how do I get the base molten without burning the two pieces that form the 1/8" gap? Are "chill bars" the only choice? MikeH 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding question - | Michael Horowitz | Restoration | 11 | September 7th 06 04:52 PM |
| Welding question: reinforce by inner sleeve | Michael Horowitz | Home Built | 7 | June 12th 06 08:11 PM |
| Welding question: 43-13-1B, Fig.4-43 | Mike | Restoration | 0 | May 15th 06 03:36 PM |
| Welding question | Mike | Restoration | 4 | February 20th 06 03:23 PM |
| Welding question | Michael Horowitz | Home Built | 1 | October 13th 05 10:53 PM |
Threaded Mode