|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 19th 08, 04:08 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welded Patch Repair question
I'm working with 4130.
I have a piece of tubing with a series of rust holes which do not cover an area greater than 1/2 ", so it appears a welded patch repair would be appropriate. Reading 43.13,, Figure 4-36, it appears the patch tube will have to be expanded in diameter in order to fit over the injured tube (can't slip the patch over the injured tubefrom an end). Will there be any problem if I heat the patch so I can open open it and slip it over the injured tubing? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stressed Skin Repair Question | RPM the A&P | Home Built | 9 | July 16th 08 04:59 AM |
| 4130 can't be OA welded? | wright1902glider | Home Built | 61 | January 4th 08 05:19 AM |
| Magneto Repair vs Overhaul Question. | Ebby | Home Built | 6 | February 24th 07 05:55 PM |
| 172 Repair question | Brad Mallard | Home Built | 2 | June 11th 04 02:54 AM |
| 172 Repair question | Brad Mallard | Aviation Marketplace | 3 | June 11th 04 02:54 AM |
Threaded Mode