![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
My Ilec normaly does a great job calculating the wind while ridge
soaring here in Hood River, Oregon, but for the last few flights it has not been giving me the correct wind, even with lots of circling. It was off about 45 degrees all day yesterday. I rebooted it before the flight but that didn't seem to help. Has any one else seen this problem and have a fix or am I going to have to send it in again? Gary Boggs |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vector Wind, Relative Wind calculation C 302/303 | [email protected] | Soaring | 2 | December 9th 08 07:23 PM |
Wind tunnel, Germany WWII (or close) - wind-tunnel-test.jpg (1/1) | JR[_2_] | Aviation Photos | 0 | August 13th 08 09:36 PM |
Wind tunnel, Germany WWII (or close) - wind-tunnel-test.jpg (0/1) | JR[_2_] | Aviation Photos | 0 | August 13th 08 09:35 PM |
Wind is fun | Dave J | Piloting | 17 | May 15th 07 12:21 AM |
Wind | john smith | Piloting | 11 | October 25th 05 04:05 AM |