|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 18th 09, 02:41 AM
posted to rec.aviation.soaring
|
|||
|
|||
How to add an IGC validation DLL to Winscore ?
Anybody know the procedure to add a manufacturer's validation DLL to
Winscore ? IC-xxx.DLL is on the computer in \windows\system32 with some others but winscore says there's no validation available for manufacturer xxx... No mention in the WInScore manual... Thanks in advance, Best Regards, Dave "YO electric" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How does Winscore calculate finish altitude? | kirk.stant | Soaring | 46 | July 31st 07 07:38 PM |
| WinScore Question | Ray Lovinggood | Soaring | 2 | June 5th 07 03:15 PM |
| OLC validation | Ken Bell | Soaring | 0 | February 25th 07 05:21 PM |
| OLC validation | Ken Bell | Soaring | 1 | February 25th 07 04:35 PM |
| Winscore source code now available | Guy Byars | Soaring | 0 | February 5th 04 10:43 AM |
Threaded Mode