Sheet Metal Brake in Northern California?

Does anyone have in their shop, or have complete access to, a sheet
metal brake, either a leaf/box brake or a press brake, at least 4 feet
in capacity, within a 2 hour drive of Oakland, CA? I need one to bend
up the longerons of my project. Contact me offline if you do.

What are the dimensions and material of the part?

Thanks, Bob K.

Check with your local community college. Most of them have metal shop
classes and all the ones I've seen can handle the 8' edge of a 4x8 sheet.

If push comes to shove and they won't let you have an hour or so on it, just
register for the class and punch out the first week of classes; you get all
your money back.

If you can't find one, I know Sierra College in Rocklin has one and I'm
faculty there.

Jim

In article ,
"RST Engineering - JIm" wrote:

Check with your local community college. Most of them have metal shop
classes and all the ones I've seen can handle the 8' edge of a 4x8 sheet.

If push comes to shove and they won't let you have an hour or so on it, just
register for the class and punch out the first week of classes; you get all
your money back.

If you can't find one, I know Sierra College in Rocklin has one and I'm
faculty there.

Jim

Just make sure that you read and follow the manual on bend relief before
you put it in the brake; OTW you will have a handful of aluminum scrap.

--
Remove _'s from email address to talk to me.