|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 19th 09, 12:51 AM
posted to rec.aviation.soaring
|
|||
|
|||
removing transparency coating
I am trying to remove the spray coating that was sprayed on my
transparency for shipping. Stuff has been on there for over 3 or more years now and it might take me that long just trying to remove the damn stuff. Any advice from those who might have some experience with this tenacious film? Thanks, Brad 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Penalitel anit-corrosion coating | Jon Woellhaf | Owning | 2 | June 27th 07 07:11 PM |
| Coating aluminum | Lou | Home Built | 23 | December 24th 05 05:11 AM |
| How to identify fabric/coating process used? | Wallace Berry | Home Built | 7 | October 7th 05 08:14 PM |
| Doors Open On New Powder Coating Facility Anaheim California United States | [email protected] | Home Built | 0 | October 21st 04 03:33 PM |
| Suitable coating for spring-steel wire? | Wright1902Glider | Home Built | 6 | February 9th 04 05:12 PM |
Threaded Mode