|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 22nd 04, 04:44 PM
|
|||
|
|||
Good Paint Remover?
I'm planning on repainting the upper tailcone on my Piper Warrior because
the paint is chipping badly. I suspect it was caused by improper preparation prior to the original paint job of this replacement part. Can someone recommend a good and safe paint remover for this material? I believe it's fiberglass but it could be plastic--if that will make a difference to the paint remover. Thanks, Marco Posted Via Usenet.com Premium Usenet Newsgroup Services ---------------------------------------------------------- ** SPEED ** RETENTION ** COMPLETION ** ANONYMITY ** ---------------------------------------------------------- http://www.usenet.com 
|
|
#2
June 22nd 04, 05:44 PM
|
|||
|
|||
|
In article , Marco Leon wrote:
I'm planning on repainting the upper tailcone on my Piper Warrior because the paint is chipping badly. I suspect it was caused by improper preparation prior to the original paint job of this replacement part. Can someone recommend a good and safe paint remover for this material? I believe it's fiberglass but it could be plastic--if that will make a difference to the paint remover. Staz Wet from Redam www.redam.com
|
|
#3
June 22nd 04, 07:58 PM
|
|||
|
|||
|
Exactly what I was looking for. Thanks!
Marco "EDR" wrote in message ... In article , Marco Leon wrote: I'm planning on repainting the upper tailcone on my Piper Warrior because the paint is chipping badly. I suspect it was caused by improper preparation prior to the original paint job of this replacement part. Can someone recommend a good and safe paint remover for this material? I believe it's fiberglass but it could be plastic--if that will make a difference to the paint remover. Staz Wet from Redam www.redam.com Posted Via Usenet.com Premium Usenet Newsgroup Services ---------------------------------------------------------- ** SPEED ** RETENTION ** COMPLETION ** ANONYMITY ** ---------------------------------------------------------- http://www.usenet.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are pilots really good or just lucky??? | Icebound | Instrument Flight Rules | 68 | December 9th 04 01:53 PM |
| Good first partnership or not? 1/6th Cherokee 140 Share in CA | noah | Owning | 18 | March 27th 04 12:33 AM |
| Midwest Paint Shops again | Brinks | Owning | 3 | March 21st 04 01:14 PM |
| bulding a kitplane maybe Van's RV9A --- a good idea ????? | Flightdeck | Home Built | 10 | September 9th 03 07:20 PM |
| Commander gives Navy airframe plan good review | Otis Willie | Military Aviation | 0 | July 8th 03 09:10 PM |
Hybrid Mode
