|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 29th 04, 10:46 PM
|
|||
|
|||
A-65 exhaust stud specs
Anyone know the thread size(s) of the exhaust studs on A-65 cylinders?
|
|
#2
March 1st 04, 12:51 AM
|
|||
|
|||
|
"Jerry Jensen" wrote in message ... Anyone know the thread size(s) of the exhaust studs on A-65 cylinders? 5/16-24 on the exhaust pipe end. Use those brass nuts purchasable from Spruce or Wicks and they will last longer.
|
|
#3
March 2nd 04, 05:36 AM
|
|||
|
|||
|
jls wrote:
"Jerry Jensen" wrote in message ... Anyone know the thread size(s) of the exhaust studs on A-65 cylinders? 5/16-24 on the exhaust pipe end. Use those brass nuts purchasable from Spruce or Wicks and they will last longer. And I think the end that goes into the cylinder is coarse thread. -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =-----
|
|
#4
March 2nd 04, 12:53 PM
|
|||
|
|||
|
"Phil Sisson, Litchfield Aerobatic Club" wrote in message ... jls wrote: "Jerry Jensen" wrote in message ... Anyone know the thread size(s) of the exhaust studs on A-65 cylinders? 5/16-24 on the exhaust pipe end. Use those brass nuts purchasable from Spruce or Wicks and they will last longer. And I think the end that goes into the cylinder is coarse thread. Exactly.
|
|
#5
March 3rd 04, 01:13 AM
|
|||
|
|||
|
thanks all
" jls" wrote: "Phil Sisson, Litchfield Aerobatic Club" wrote in message ... jls wrote: "Jerry Jensen" wrote in message ... Anyone know the thread size(s) of the exhaust studs on A-65 cylinders? 5/16-24 on the exhaust pipe end. Use those brass nuts purchasable from Spruce or Wicks and they will last longer. And I think the end that goes into the cylinder is coarse thread. Exactly.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SS exhaust ball joints | Stu | Home Built | 1 | January 3rd 04 10:34 PM |
| Exhaust Tape | RobertR237 | Home Built | 19 | July 30th 03 03:06 AM |
| Exhaust for VW motor | Andre | Home Built | 0 | July 14th 03 03:14 PM |
Hybrid Mode
