Anyone have a Grob 103 Twin II handy to take a couple of measurements?

I need the following:

- Chord at the root
- Chord at the tip
- Semi-span including spar (so from wingtip to opposite side of fuselage)
- Chord of vertical stabilizer plus rudder
- Height of vertical stabilizer plus rudder (bottom of fuselage to top of vertical stabilizer)

Thanks in advance if anyone can do this.

P3

Three view, ruler, calculator, but no spreadsheet. :-)

On Thursday, June 11, 2015 at 12:29:56 PM UTC-4, Steve Leonard wrote:
Three view, ruler, calculator, but no spreadsheet. :-)

Yeah, I thought of that. The three view I have leaves me a little suspicious on the fidelity of the drawing vs. the real thing. Probably good enough for my purposes (trailer dimensioning).

P3

On Thursday, June 11, 2015 at 2:00:55 PM UTC-4, Papa3 wrote:
On Thursday, June 11, 2015 at 12:29:56 PM UTC-4, Steve Leonard wrote:
Three view, ruler, calculator, but no spreadsheet. :-)

Yeah, I thought of that. The three view I have leaves me a little suspicious on the fidelity of the drawing vs. the real thing. Probably good enough for my purposes (trailer dimensioning).

P3

Try these guys, they might know :-)

E-Mail:
www.ltb-lindner.com

They also have drawings at
http://www.ltb-lindner.com/drawings.html


Are you not able to go to the airport right now ?

Todd

On Thursday, June 11, 2015 at 2:18:23 PM UTC-4, wrote:
On Thursday, June 11, 2015 at 2:00:55 PM UTC-4, Papa3 wrote:
On Thursday, June 11, 2015 at 12:29:56 PM UTC-4, Steve Leonard wrote:
Three view, ruler, calculator, but no spreadsheet. :-)

Yeah, I thought of that. The three view I have leaves me a little suspicious on the fidelity of the drawing vs. the real thing. Probably good enough for my purposes (trailer dimensioning).

P3

Try these guys, they might know :-)

E-Mail:
www.ltb-lindner.com

They also have drawings at
http://www.ltb-lindner.com/drawings.html


Are you not able to go to the airport right now ?

Todd

Thanks - hadn't seen the dimensioned drawings before. This will do it for my purposes. I'll compare to the real article tomorrow.

P3

On Thursday, June 11, 2015 at 12:29:56 PM UTC-4, Steve Leonard wrote:
Three view, ruler, calculator, but no spreadsheet. :-)

Reminds of a guy I know who built a trailer for his Libelle from
the 3-view. It was pretty funny when he tried to roll the Libelle
into his just completed trailer, only to find the tail didn't fit!
The 3-view showed the original somewhat shorter vertical tail.

See ya, Dave

PS: No, I'm not going to tell you who that was...

M&M Manufacturing in Moriarity has built a couple of open trailers for the Grob 103. I think he may know the dimensions.
BillT