|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 10th 04, 10:04 PM
|
|||
|
|||
iPAQ connection to Filser 5000 Slave
The LX-5000 has a 9-pin connector for an iPAQ, but the slave (back-seat)
does not appear to have the same type of wiring setup. Can anyone give me a hand on completing the wiring between the slaved Filser and the iPAQ? Thanks, Roderick 
|
|
#2
April 13th 04, 07:31 AM
|
|||
|
|||
|
"Rod" wrote in message ...
The LX-5000 has a 9-pin connector for an iPAQ, but the slave (back-seat) does not appear to have the same type of wiring setup. Can anyone give me a hand on completing the wiring between the slaved Filser and the iPAQ? Thanks, Roderick Hi Have a look at http://www.filser.de/index/language=...t=d_variometer There you can download a PDF with the needed information. It should also have an english version - page 45. Regards.
|
|
#3
April 14th 04, 11:01 PM
|
|||
|
|||
|
Thanks for the tip.
Regards, Rod
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Commercial - iPAQ Cradle Changes | Paul Remde | Soaring | 0 | April 9th 04 03:29 PM |
| Questions for any iPaq users out there | Ted Wagner | Soaring | 4 | April 7th 04 03:25 PM |
| iPaq wiring, cradles and mounts for gliders - Ideas?? | Jim Kelly | Soaring | 12 | December 4th 03 11:45 PM |
| iPAQ h2210/h2215 Review | Paul Remde | Soaring | 0 | September 3rd 03 03:45 AM |
Hybrid Mode
