![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() https://en.wikipedia.org/wiki/Conair_Firecat The Conair Firecat is a fire-fighting aircraft developed in Canada in the 1970s by modifying military surplus Grumman S-2 Trackers. The modifications were developed by the maintenance arm of the Conair Group, which became a separate company called Cascade Aerospace. The Firecats are retrofitted Grumman S-2 Trackers. Conair bought a large number of Trackers formerly operated by the Canadian Navy and a small number of ex-United States Navy aircraft as well. The Trackers are modified for aerial firefighting as Firecats by raising the cabin floor by 20 cm (8 in) and fitting a 3,296 litre (870 U.S. gal) retardant tank where the torpedo bay is normally located. All superfluous military equipment is removed and the empty weight is almost 1,500 kg lower than a Tracker's. The first aircraft was modified in 1978. Some examples have been re-engined with turboprop engines and are known as Turbo Firecats, these feature a larger tank and extra underwing fuel tanks; the Maximum Take Off Weight (MTOW) is increased by 680 kg (1,500 lb) to 12,480 kg (27,500 lb), while the lighter turbine engines also reduce the empty weight. The first Turbo Firecat was produced in 1988. Role Fire-fighting aircraft National origin Canada Manufacturer Conair Introduction 1978 (Firecat) 1988 (Turbo Firecat) Retired Retired in Canada 2012 Status Active in France with Sécurité Civile (Turbo Firecat only) Primary users Conair Sécurité Civile Number built 35 Conair commenced Firecat operations in 1978. Firecats and Turbo Firecats were previously in service with Conair and the Government of Saskatchewan in Canada and were also used by the Government of Ontario. The Sécurité Civile organisation in France took delivery of 14 Firecats over a period of five years commencing in May 1982. It has had its examples further converted and is now standardized on the Turbo Firecat. A total of 35 Firecat and Turbo Firecat conversions have been performed; four Firecats and three Turbo Firecats have crashed in France. As of 2016; a total of 9 Turbo Firecats remain in service for Sécurité Civile in France. Similar conversions are performed by another company Marsh Aviation in the United States. These are known as Marsh Turbo Trackers and feature Garrett AiResearch TPE-331 turboprop engines. Variants Firecat Original version, fitted with Wright R-1820 radial piston engines as fitted to standard Grumman Trackers Turbo Firecat Version fitted with two Pratt & Whitney Canada PT6A-67AF turboprop engines Specifications (Turbo Firecat) General characteristics Crew: 1 Capacity: 3,395 l (897 U.S. gal) of water, plus 173 l (46 U.S. gal) of foam concentrate Length: 13.26 m (43 ft 6 in) Wingspan: 22.12 m (72 ft 7 in) Height: 5.05 m (16 ft 7 in) Empty weight: 6,803 kg (15,000 lb) Gross weight: 12,473 kg (27,500 lb) Powerplant: 2 × Pratt & Whitney Canada PT6A-67AF, 761 kW (1,220 hp) each Performance Maximum speed: 407 km/h (253 mph) Endurance: 5 hours 6 min * |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wendover AFB, January 2010 (with Conair prop) | coffelt2 | Aviation Photos | 2 | February 1st 10 08:46 AM |