|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 7th 05, 08:13 AM
|
|||
|
|||
Need some help identifying an AN fitting
I've got a stainless AN fitting (that came with my motor parts) that I could
use some help identifying. Photos and explanation are posted: http://www.weldingfaq.com/turbine2.asp#fitting Thanks! Larry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mandrel for 306/-2 (1/8 in) and 471-2 fitting? | Boelkowj | Home Built | 2 | February 6th 05 03:00 PM |
| quick disconnect hydraulic fitting | [email protected] | Home Built | 8 | January 7th 05 04:28 PM |
| Identifying an Aircraft Firing Trigger Mechanism | Tasp | Military Aviation | 3 | August 13th 04 08:40 PM |
| Straight restrictor fitting? | nauga | Home Built | 5 | April 15th 04 02:06 PM |
| Identifying aircraft | Rod Chavez | Restoration | 1 | July 26th 03 10:54 PM |
Hybrid Mode
