![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
In September 2004 issue of AOPA Flight Training, Mark Cook has an article,
"No Fueln' Around". Under the "Selector boy" side article, he mentions that he runs some of his tanks dry in his Bellanca Viking. In at least one of John Deakin's articles (http://www.avweb.com/news/columns/182044-1.html), he not only recommends running tanks dry but puts forth a powerful argument that it's a responsible fuel management strategy. Furthermore, Deakin also offers that he has never found an NTSB accident report related to a failed engine start when running a tank dry and switching to the next. Both guys recommend setting a timer a couple of minutes before the tank should run dry; which acts of both early warning and as validation of your anticipated fuel consumption. Is this common? How many run their tank(s) dry as part of their fuel management strategy? If you don't run dry, why not? Aside from the heat beat skipping which is sure to follow the first couple of times, what's the down side to this strategy? Lastly, I did cross post this message as I feel it's of value to both student and general pilot population alike. Cheers, Greg |
#2
|
|||
|
|||
![]()
Greg Copeland wrote:
Is this common? How many run their tank(s) dry as part of their fuel management strategy? If you don't run dry, why not? Aside from the heat beat skipping which is sure to follow the first couple of times, what's the down side to this strategy? I would like to do this just one time for each of the two main tanks in the Bonanza V35 I fly if for no other reason than to validate the actual duration and total gallons. However, I have yet to take the time or have the courage to do so. As far as disadvantages, I am concerned about what might happen with the sediment in these aging fuel bladders as the fuel empties. But, I have read articles that dispel this myth so perhaps this is a non-issue. -- Peter ----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups ----= East and West-Coast Server Farms - Total Privacy via Encryption =---- |
#3
|
|||
|
|||
![]()
On Thu, 18 Aug 2005 09:58:18 -0400, Peter R. wrote:
Greg Copeland wrote: Is this common? How many run their tank(s) dry as part of their fuel management strategy? If you don't run dry, why not? Aside from the hea[r]t beat skipping which is sure to follow the first couple of times, what's the down side to this strategy? I would like to do this just one time for each of the two main tanks in the Bonanza V35 I fly if for no other reason than to validate the actual duration and total gallons. However, I have yet to take the time or have the courage to do so. As far as disadvantages, I am concerned about what might happen with the sediment in these aging fuel bladders as the fuel empties. But, I have read articles that dispel this myth so perhaps this is a non-issue. Deakin's article specifically mentions this. I recommend you read the article. He argues this is nothing to worry about and even indirectly offers this is a reason to run your tanks dry. Greg |
#4
|
|||
|
|||
![]()
On Thu, 18 Aug 2005 09:07:14 -0500, Greg Copeland wrote:
I would like to do this just one time for each of the two main tanks in the Bonanza V35 I fly if for no other reason than to validate the actual duration and total gallons. However, I have yet to take the time or have the courage to do so. I'd like to know exactly how much fuel is useable, too, but think I'd probably run a tank low, pump out the remaining gas, then either high idle or taxi around until it sputtered, switch over, then fill the empty tank. Seems waaay too much hassle to not just believe the manufacturer. If you choose to do this when flying, please don't have either me or your insurance agent as a passenger. As far as disadvantages, I am concerned about what might happen with the sediment in these aging fuel bladders as the fuel empties. But, I have read articles that dispel this myth so perhaps this is a non-issue. In my day job, I operate a 2005 vehicle, and see the gunk that comes out of fuel filters regularly. I can hardly imagine what could lurk in the +/- 30 year old tanks on aircraft we trust to keep us out of the trees. Enjoy your experiment Jim Ricks |
#5
|
|||
|
|||
![]()
In rec.aviation.piloting James Ricks wrote:
I'd like to know exactly how much fuel is useable, too, but think I'd probably run a tank low, pump out the remaining gas, then either high idle or taxi around until it sputtered, switch over, then fill the empty tank. Seems waaay too much hassle to not just believe the manufacturer. If you choose to do this when flying, please don't have either me or your insurance agent as a passenger. I routinely run tanks dry on long flights. As I know my plane and know when a tank is about to empty, chances are that you, my insurance agent, or my somewhat nervous wife or children ever notice that a tank went dry. My first warning is a tank is about to dry is that my timer runs out. A few minutes later I see a slight increase in my EGT (I've a good engine monitor). About 40 seconds later, my fuel pressure gauge twitches. I then switch tanks and the engine hasn't even burbled. Nobody notices. BTW, Beech sez I've got 20 gallon tanks, with 17.5 usable. After running my right tank dry, I can put fill with 20.8 gallons. My aux tank tank is 20 with 19 usable according to the book. After running it dry, I can put 19.7 in it. I don't know how much I can put in my left one as I only have three tanks and I try hard not to have all three of them empty at one time ;-) Fortunately, what Beech put in my owners book were written by engineers with an engineers fudge factor. The books on later models were written by lawyers using the engineers data (with the afore mentioned fudge factor). Way lotta slop there. In my day job, I operate a 2005 vehicle, and see the gunk that comes out of fuel filters regularly. I can hardly imagine what could lurk in the +/- 30 year old tanks on aircraft we trust to keep us out of the trees. Does your 2005 vehicle have sumps that you drain every time before you start it? -- Frank Stutzman Bonanza N494B "Hula Girl" Hood River, OR |
#6
|
|||
|
|||
![]()
BTW, Beech sez I've got 20 gallon tanks, with 17.5 usable. After running
my right tank dry, I can put fill with 20.8 gallons. [...] Fortunately, what Beech put in my owners book were written by engineers with an engineers fudge factor. [...] Way lotta slop there. "Usable" means usable in EVERY flight attitude. The "unusable" fuel can be used in SOME flight attitudes, obviously some of that unusable fuel could be used in the specific flight attitude in which you were at the time. Jose -- Quantum Mechanics is like this: God =does= play dice with the universe, except there's no God, and there's no dice. And maybe there's no universe. for Email, make the obvious change in the address. |
#7
|
|||
|
|||
![]()
On Thu, 18 Aug 2005 09:58:18 -0400, Peter R. wrote:
Greg Copeland wrote: As far as disadvantages, I am concerned about what might happen with the sediment in these aging fuel bladders as the fuel empties. But, I have read articles that dispel this myth so perhaps this is a non-issue. Opps. I misread that. I read that has "have not"...obviously you have. Ignore my suggestion to read the article. ![]() Greg |
#8
|
|||
|
|||
![]()
I bought a fuel computer (JPI add-on to my EDM). I know exactely how
much fuel is in each tank. |
#9
|
|||
|
|||
![]()
Not quite; it only tells you what goes through the flowmeter. If you
have a leak before the fuel gets to the meter, the only way you'll know is if the plane catches fire or the gauges go down too fast :-) |
#10
|
|||
|
|||
![]()
Robert,
I know exactely how much fuel is in each tank. Nope, you don't. In fact, without running the tanks dry at least once (or emptying them in the hangar), you have no idea. You know how much has gone from the tanks if there is no leak. That doesn't tell you at all how much is left. -- Thomas Borchert (EDDH) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time, running out of fuel and fuel gauges | Dylan Smith | Piloting | 29 | February 3rd 08 07:04 PM |
Engine running again, the good, bad and ugly | Corky Scott | Home Built | 34 | July 6th 05 05:04 PM |
It's finally running! | Corky Scott | Home Built | 19 | April 29th 05 04:53 PM |
Rotax 503 won't stop running | Tracy | Home Built | 2 | March 28th 04 04:56 PM |
Leaving all engines running at the gate | John | Piloting | 12 | February 5th 04 03:46 AM |