![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I'd like to replace my side windows this winter. Will working with
plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? -- Ben Jackson http://www.ben.com/ |
#2
|
|||
|
|||
![]() "Ben Jackson" wrote in message ... I'd like to replace my side windows this winter. Will working with plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? Depends on the adhesive, read the label. -- Ben Jackson http://www.ben.com/ |
#3
|
|||
|
|||
![]() "Michael Ware" wrote in message news ![]() "Ben Jackson" wrote in message ... I'd like to replace my side windows this winter. Will working with plexiglass be substantially harder with temps in the 30-40F range? Will the adhesives cure or will I need to heat the hangar? Warmth is definately your friend if you are going to drill, sand, trim plexiglass. Trust me I do it for a living. Scott. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Winter Vario | [email protected] | Soaring | 2 | August 17th 05 08:24 AM |
Tie-down winter hazards | [email protected] | Owning | 6 | January 12th 05 10:23 PM |
Winter Flying | [email protected] | Piloting | 36 | January 3rd 05 03:19 AM |
Air Force Working to Combat Stressors | Otis Willie | Military Aviation | 0 | September 18th 04 03:54 AM |
Air Force Museum Working Group to release final report | Otis Willie | Military Aviation | 0 | November 18th 03 12:28 AM |