![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I just upgraded to a 496. Is there some great software to transfer my user
waypoints and routes from a 396? Thanks, Karl And a little SPAM he I hope this doesn't upset MX and Burnbutt. http://tinyurl.com/2tg4pt |
#2
|
|||
|
|||
![]() karl gruber wrote: I just upgraded to a 496. Is there some great software to transfer my user waypoints and routes from a 396? Yep, here you go. It will take waypoints and routes from any GPS and move it to any GPS. http://www.easygps.com/ |
#3
|
|||
|
|||
![]()
Thanks.......got it done last night.
Best, Karl...496 equipped Kind of like the A90 King Air I used to fly. Right by the door it said "Radar Equipped." Too bad it wasn't equipped with a decent HEATER! It had a strange system of pressurization for a turboprop. Even though there was bleed air, Beech used a gear driven supercharger to supply pressurization. It robbed 40 pounds of torque from the left engine. The Janitrol heater was great, but it OFTEN went out. No amount of maintenance, overhaul, new...would EVER keep it running. There was a great knob to pull though. It was labeled "Supercharger Heat." I'd pull that and the cabin would at least SMELL hot! I think pressurized air would then come off the supercharger and bypass an inline heat exchanger. Best again! "Newps" wrote in message . .. karl gruber wrote: I just upgraded to a 496. Is there some great software to transfer my user waypoints and routes from a 396? Yep, here you go. It will take waypoints and routes from any GPS and move it to any GPS. http://www.easygps.com/ You can use the Garmin Mapsource software to do it. Just download it from the Garmin webpage, hook up the 396, select "receive from device" in Mapsource, when it's done, hook up the 496, and select "Send to device". It will transfer all waypoints and routes |
#4
|
|||
|
|||
![]()
You can use the Garmin Mapsource software to do it. Just download it
from the Garmin webpage, hook up the 396, select "receive from device" in Mapsource, when it's done, hook up the 496, and select "Send to device". It will transfer all waypoints and routes. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Garmin 430 Training Software? | Mitty | Instrument Flight Rules | 4 | August 29th 05 03:05 AM |
garmin + see you software | Willie G | Soaring | 3 | March 1st 05 11:19 PM |
Software for garmin 100 | Mark Tolson | Soaring | 1 | April 21st 04 02:39 PM |
Garmin 430 Training Software | HankPilot2002 | Piloting | 7 | February 16th 04 03:26 AM |
Garmin 430 Training Software | HankPilot2002 | Piloting | 2 | November 24th 03 04:19 PM |