taper pins

What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------

Lemmie look, I gotta bunch--Jerry--also the reamers-(only one each)

Ernest Christley wrote:

What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------

Nope, Sorry, got some 1-9's & some 2-14-a's

Ernest Christley wrote:

What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------

Ernest Christley wrote in message .com...
What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

Try ebay? This listing is for 4-27s, but who knows what will show up
next week? http://cgi.ebay.com/ebaymotors/ws/eB...m=2431553 561

You might think about using standard taper pins, used in machinery. Several
local hardware stores around here stock them, in a variety of sizes. NOTE:
they use a different taper than the AN jabbados. And you'd have to figure
out how to retain them yourself.

But typically they run from .60 to mebbe 3 bucks each, depending on size.

For an experimental, of course.
--
Ryan R Young
Oakland, CA
http://users.lmi.net/~ryoung

From: Ernest Christley
Organization: Road Runner - NC
Newsgroups: rec.aviation.homebuilt
Date: Wed, 10 Sep 2003 13:36:12 GMT
Subject: taper pins

What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------