|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 7th 08, 02:40 PM
posted to rec.aviation.owning
|
|||
|
|||
Adhesive Recommendation?
One of the rubber pads came off one of my rudder pedals the other day.
Anybody have a good adhesive they can recommend for rubber to metal? Steve PA28-151 KDMW 
|
|
#2
October 7th 08, 03:35 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
One of the best all-around adhesives I have found is 'Goop'. It seems to
form a tough bond with almost anything. -- Best Regards, Mike. http://flickr.com/photos/mikenoel/ http://photoshow.comcast.net/mikenoel "Steve - KDMW" wrote in message ... One of the rubber pads came off one of my rudder pedals the other day. Anybody have a good adhesive they can recommend for rubber to metal? Steve PA28-151 KDMW
|
|
#3
October 7th 08, 05:19 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
Mike Noel wrote:
One of the best all-around adhesives I have found is 'Goop'. It seems to form a tough bond with almost anything. Probably a good recommendation. I was going to suggest a contact cement. Be sure all surfaces are clean and follow the label instructions. -- Regards, Ross C-172F 180HP KSWI
|
|
#4
October 7th 08, 05:33 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
Steve - KDMW wrote:
One of the rubber pads came off one of my rudder pedals the other day. Anybody have a good adhesive they can recommend for rubber to metal? That was a recurring problem for my Cherokee. In the desert heat, adhesives tended to lose their grip over time. I solved the problem by using black zip ties to hold the rubber pads on the pedals. John Galban=====N4BQ (PA28-180) -- Message posted via AviationKB.com http://www.aviationkb.com/Uwe/Forums...ation/200810/1
|
|
#5
October 7th 08, 06:30 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
"JGalban via AviationKB.com" u32749@uwe wrote in message
news:8b51498a7260d@uwe... Steve - KDMW wrote: One of the rubber pads came off one of my rudder pedals the other day. Anybody have a good adhesive they can recommend for rubber to metal? That was a recurring problem for my Cherokee. In the desert heat, adhesives tended to lose their grip over time. I solved the problem by using black zip ties to hold the rubber pads on the pedals. I did the same thing to mine in the Warrior. Put them on about 8 years ago and they're still holding the pads onto the pedal. (Of course now that I posted this message they'll probably fall off tomorrow!) Marco
|
|
#6
October 7th 08, 06:45 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
I've had success using 3M auto trim adhesive.
"Steve - KDMW" wrote in message ... One of the rubber pads came off one of my rudder pedals the other day. Anybody have a good adhesive they can recommend for rubber to metal? Steve PA28-151 KDMW
|
|
#7
October 8th 08, 07:28 PM
posted to rec.aviation.owning
|
|||
|
|||
|
Adhesive Recommendation?
What do they use for golf clubs?
If anything is going to slip it would be the clubs.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adhesive | [email protected] | Owning | 7 | August 29th 06 04:15 AM |
| Adhesive | [email protected] | Restoration | 3 | August 25th 06 03:41 AM |
| Adhesive | [email protected] | Owning | 6 | August 23rd 06 05:33 PM |
| adhesive | [email protected] | Piloting | 2 | August 20th 06 12:30 PM |
| structural adhesive | circio0 | Home Built | 5 | May 30th 06 09:34 AM |
Hybrid Mode
