|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
March 8th 04, 02:27 AM
|
|||
|
|||
I have mine manually disabled, I do it because I dont like the gear comming down
untill I am ready and I like putting it up when I am ready. Roy Smith wrote: In article bwc1c.12546$id3.4348@fed1read01, "BTIZ" wrote: BTW, I'm not sure about the older 180HP arrows, but most of the newer Arrows have the auto extend mechanism disabled by either an AD or a Service Bulletin. Why would you want to disable it? 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Auto conversions & gear boxes | Dave Covert | Home Built | 56 | April 1st 04 06:19 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
Linear Mode
