|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 12th 04, 08:35 PM
|
|||
|
|||
wood grain question.
Stealth Pilot wrote in message . ..
that is pretty well my take on it as well. I was wondering whether I'd missed something in the reading along the way. oh well bugger the waste. we saw for quarter grain. the stuff grows on trees anyway :-) If you have tight grained flatsawn lumber you can rip it into narrow strips, rotate the strips 90 degrees and glue them to make vertically-grained glue-laminations. -- FF 
|
|
#2
December 6th 04, 02:13 PM
|
|||
|
|||
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
| Using Balsa wood | Lou Parker | Home Built | 10 | December 8th 03 05:08 PM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 07:45 PM |
| Direction of warping wood? | BllFs6 | Home Built | 2 | September 1st 03 10:52 AM |
Linear Mode
