![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Jay --
Some time ago there was a thread in this ng about what sort of light aircraft on a pole ("pig on a stick") would be appropriate for your establishment. That thread sort of bogged down... Just for grins, go to http://www.rst-engr.com/weathervane/ and think about making a 4x or 8x model of this thing. It is the July/August/September Kitplanes project column device. Note the red/green wingtip lights, the white tailfeathers light, and the red flashing rotating beacon atop the vertical fin. While I used plain old T1 size LEDs on this little rascal for weight, we could use the moosey stoplight size on a larger model. I can design the electronics if you can get somebody in your neck of the woods to do the woodwork and metalwork. I used an off-the-shelf gas engine model airplane propeller for the model; you will have to do some thinking about what you want to use on a larger model. Yes, the prop spins in the slightest breeze. Jim |
#2
|
|||
|
|||
![]()
Jim,
Not to be to critical, but you should be thinking on a bigger scale for Jay. Something along these lines :-) http://www.pilotmarket.com/category/...and_Hangars/6/ http://www.airplanehome.com/ http://cgi.ebay.com/ebaymotors/ws/eB...tem=2485893359 Ronnie "RST Engineering" wrote in message ... Jay -- Some time ago there was a thread in this ng about what sort of light aircraft on a pole ("pig on a stick") would be appropriate for your establishment. That thread sort of bogged down... Just for grins, go to http://www.rst-engr.com/weathervane/ and think about making a 4x or 8x model of this thing. It is the July/August/September Kitplanes project column device. Note the red/green wingtip lights, the white tailfeathers light, and the red flashing rotating beacon atop the vertical fin. While I used plain old T1 size LEDs on this little rascal for weight, we could use the moosey stoplight size on a larger model. I can design the electronics if you can get somebody in your neck of the woods to do the woodwork and metalwork. I used an off-the-shelf gas engine model airplane propeller for the model; you will have to do some thinking about what you want to use on a larger model. Yes, the prop spins in the slightest breeze. Jim |
#3
|
|||
|
|||
![]()
("nobody" wrote)
[snip] Not to be to critical, but you should be thinking on a bigger scale for Jay. Or smaller... White plastic round Hilex bleach bottle. Cut out maybe seven fins from the side of the plastic bottle. Fold the fins out maybe 45 degrees to catch the wind. This is important: Paint the fins red, then leave one white, then blue, then one white again. Repeat. Put 'front yard art' up in the front yard, on an old round wooden tomato stake. Now, sit back in your lawn chair and watch your creation spin in the wind. Ball game should be playing on the transistor radio while you enjoy a cold one - for the full affect. Montblack Don't thank me, thank Better Homes and Gardens (1965?) |
#4
|
|||
|
|||
![]()
At the Whitehorse, Yukon Territory airport, the wind tee is a DC-3. A
real DC-3, on a pedestal. It rotates. vince norris |
#5
|
|||
|
|||
![]()
("vincent p. norris" wrote)
At the Whitehorse, Yukon Territory airport, the wind tee is a DC-3. A real DC-3, on a pedestal. It rotates. http://www.douglasdc3.com/dc3vane/dc3vane.htm DC-3 on a stick ....fun!!! http://www.explorenorth.com/library/...on/cf-cpy.html More DC-3 ... "The World's Largest Weather Vane." http://www.centercomp.com/cgi-bin/dc3/gallery?5038 Puting it back up on the post after restoration Montblack |
#6
|
|||
|
|||
![]()
I see you're (once again) not getting out much Paul. :-)
I, on the other hand, flew *my plane* to a fly-in today. Watsonville, CA. Arrival was a piece of cake compared to Oshkosh (which, IMHO, isn't really difficult if you can read and follow the NOTAM). Had tons of fun initiating brother Steve in the right seat. Oshkosh, here we come! Oh, wait, IOW first for Jay's little shindig :-P -- Jack Allison PP-ASEL-IA Student Arrow N2104T "When once you have tasted flight, you will forever walk the Earth with your eyes turned skyward, for there you have been, and there you will always long to return" - Leonardo Da Vinci (Remove the obvious from address to reply via e-mail) |
#7
|
|||
|
|||
![]()
On Sat, 28 May 2005 09:40:47 -0700, "RST Engineering"
wrote: Jay -- Some time ago there was a thread in this ng about what sort of light aircraft on a pole ("pig on a stick") would be appropriate for your establishment. That thread sort of bogged down... You've owned a Pilatus P6 Porter and thought it beautiful havent you :-) |
#8
|
|||
|
|||
![]()
Just for grins, go to http://www.rst-engr.com/weathervane/ and think
about making a 4x or 8x model of this thing. It is the July/August/September Kitplanes project column device. Hee hee! That's cool! I *almost* bought a giant-scale P-51 Mustang wind-vane at Sun N Fun a year or two ago. It was beautiful, about 6' long, all fiberglass, and very well made. Unfortunately, it was over a thousand bucks, and I have NO idea where I'd mount it. The problem with a wind vane is that you need dramatically more real estate for it, so that it can rotate. My frontage at the Inn (as you may recall) is a thin (~18 foot) "island" of grass directly in front of two of my three parking lots. Obviously, having a big rotating thing out there is probably a bad idea, due to proximity to the road and parked cars. Which leaves an area of grass up near the tower, which maybe gives us a circumference of 12 feet or so to play with. Trouble is, this is a pedestrian walkway! I can just imagine what my insurance guy would say about having a big rotating plane that might swing at any moment into the walkway... Ideally, we would put such a contraption over on the airport side of the hotel, on the open land between us and the road that runs between us and the field. Unfortunately, that's runway clear-space that we don't own -- and we cannot put anything permanent in that space. (I just put a big ol' 12 foot picnic table out there, and I'm waiting for someone to come tell me to remove it...) I'm afraid in the end we need something stationary, Jim. But thanks for thinking of us! (BTW: I have added an EAA windsock and a small aviation-theme rotating windvane near the hotel entrance, just for fun!) -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" |
#9
|
|||
|
|||
![]()
nobody wrote:
Something along these lines :-) http://www.pilotmarket.com/category/...and_Hangars/6/ http://www.airplanehome.com/ http://cgi.ebay.com/ebaymotors/ws/eB...tem=2485893359 Not only do you get a weathervane, but you could set up a suite in something like a 737. George Patterson Why do men's hearts beat faster, knees get weak, throats become dry, and they think irrationally when a woman wears leather clothing? Because she smells like a new truck. |
#10
|
|||
|
|||
![]()
I'm the engineer.
You are the "client". You didn't give me the whole sheet of specifications. Deal with it. {:-) Jim |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for Cessna Caravan pilots | [email protected] | Owning | 9 | April 1st 04 02:54 AM |
"I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 03:07 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 04:50 PM |