![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
See:
http://www.alexisparkinn.com/photoga..._Nosewheel.jpg Airbus may not know how to make a landing gear mechanism that works reliably, but they sure do know how to make it TOUGH. It's hard to imagine the stresses on that gear as the wheels ground themselves into oblivion... -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" |
#2
|
|||
|
|||
![]()
Jay Honeck wrote:
See: http://www.alexisparkinn.com/photoga..._Nosewheel.jpg Airbus may not know how to make a landing gear mechanism that works reliably, but they sure do know how to make it TOUGH. It's hard to imagine the stresses on that gear as the wheels ground themselves into oblivion... I don't know for sure, but it may well be that this caused less stress than the tires would at maximum braking. I'm guessing the wheels are aluminum and once it got hot and began to melt, the friction may not have been all that great. If you don't believe me, make a skid that has an aluminum plate on the bottom and make another and put cut up tire treads on it. Place a hundred pounds or so on top and then try to slide each across your driveway. Matt |
#3
|
|||
|
|||
![]()
NIce clear pic! I see that the tire is still on the right side rim.
"If in doubt, over-engineer it!" My shop teacher always said. Bryan "The Monk" Chaisone |
#4
|
|||
|
|||
![]() I think the one that landed here in Columbus a few years ago, the nosegear straightened itself out on touchdown, no damage. That is amazing, ground down to the axle. -- Hello, my name is Mike, and I am an airplane addict.... |
#5
|
|||
|
|||
![]()
Sure is amazing. Also amazing that they didn't design a failure mode
that leaves the tires aligned and locked in the aligned position when failed. |
#6
|
|||
|
|||
![]() I don't know for sure, but it may well be that this caused less stress than the tires would at maximum braking. ....after the tremendous force spike of the side loaded rubber tires. |
#7
|
|||
|
|||
![]()
"Jay Honeck" wrote in message
Airbus may not know how to make a landing gear mechanism that works reliably, but they sure do know how to make it TOUGH. It's hard to imagine the stresses on that gear as the wheels ground themselves into oblivion... They have to be tough to survive my landings! Not to mention the tug drivers at LaGuardia! Plus those JetBlue Airbusses are getting old. They're 6 years old already! :-) Last year, a Fed-Ex A-300 widebody landed at FLLwith the main wheels locked up. It stopped in 2700'. All 8 wheels were ground down to the axle. Then a DC-3 blew a tire and shut down the other wide runway. What a day! D. |
#8
|
|||
|
|||
![]()
On 2005-10-03, Capt.Doug wrote:
Last year, a Fed-Ex A-300 widebody landed at FLLwith the main wheels locked up. It stopped in 2700'. All 8 wheels were ground down to the axle. What does the flight manual say about cool down time after that kind of braking effort? -- Ben Jackson http://www.ben.com/ |
#9
|
|||
|
|||
![]() "Jay Honeck" wrote in message oups.com... See: http://www.alexisparkinn.com/photoga..._Nosewheel.jpg Airbus may not know how to make a landing gear mechanism that works reliably, but they sure do know how to make it TOUGH. It's hard to imagine the stresses on that gear as the wheels ground themselves into oblivion... -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" Good thing the wheels stayed perpendicular to the nose, if the nose wheel was cocked at 45* or something other than straight or 90* you would have a wild ride when the nose wheel touched. ------------------------------------------------ DW |
#10
|
|||
|
|||
![]()
Darkwing (Badass) wrote:
"Jay Honeck" wrote in message oups.com... See: http://www.alexisparkinn.com/photoga..._Nosewheel.jpg Airbus may not know how to make a landing gear mechanism that works reliably, but they sure do know how to make it TOUGH. It's hard to imagine the stresses on that gear as the wheels ground themselves into oblivion... -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" Good thing the wheels stayed perpendicular to the nose, if the nose wheel was cocked at 45* or something other than straight or 90* you would have a wild ride when the nose wheel touched. Yes, that would have been a real test of pilot skill. I wonder if the rudder, asymetric reverse thrust AND differential braking could overcome a 45 degree nosewheel? I'd hate to be part of the crew that had to find out. Matt |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jet engines vs. leaf blowers | 01-- Zero One | Soaring | 6 | September 8th 05 01:59 AM |
A&P heroics | Jim | Piloting | 31 | July 18th 05 07:26 PM |
Nose gear failure | Greg Esres | Owning | 12 | April 20th 04 11:03 PM |
VW-1 C-121J landing with unlocked nose wheel | Mel Davidow LT USNR Ret | Military Aviation | 1 | January 19th 04 05:22 AM |
Blue Angel's Gear Door Broken? | Clay N4AOX | Military Aviation | 15 | October 6th 03 08:01 AM |