![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
![]()
weight is a function of density, volume does not matter when
pressure is measured in PSI. "Jose" wrote in message m... | Fuel has weight, a little less than .5 pounds per foot of | distance. | | I've never heard it expressed quantitatively thus. Could you elaborate? | Weight is a function of volume, and pressure would be a function of | height. | | Jose | -- | Nothing takes longer than a shortcut. | for Email, make the obvious change in the address. |
#22
|
|||
|
|||
![]() "Jim Macklin" wrote in message news:eqeTf.118075$QW2.13026@dukeread08... Idle cutoff stops flow of fuel to the venturi/throat, but the float valve stops the flow of fuel into the carb float bowl. -- James H. Macklin ATP,CFI,A&P OK, so the float bowl is always filled as far as the (good) float/needle allows it to be while the mixture control is downstream of the float needle? Actually makes sense because the float is supposed to control the head pressure against the carb jet, and putting a cutoff in front of the float would only cause the bowl level to lower with very slight leaning due to the reduces head pressure. One of these days I'll get to mess around with one of these engines.... Thanks Jim... |
#23
|
|||
|
|||
![]()
I had a commercial pilots certificate for some time before I
attended A&P school [Spartan] and I learned that I didn't know a lot of things about aircraft engines that I think a pilot should know. -- James H. Macklin ATP,CFI,A&P -- The people think the Constitution protects their rights; But government sees it as an obstacle to be overcome. some support http://www.usdoj.gov/olc/secondamendment2.htm See http://www.fija.org/ more about your rights and duties. ".Blueskies." wrote in message t... | | "Jim Macklin" wrote in message news:eqeTf.118075$QW2.13026@dukeread08... | Idle cutoff stops flow of fuel to the venturi/throat, but | the float valve stops the flow of fuel into the carb float | bowl. | | -- | James H. Macklin | ATP,CFI,A&P | | | | OK, so the float bowl is always filled as far as the (good) float/needle allows it to be while the mixture control is | downstream of the float needle? Actually makes sense because the float is supposed to control the head pressure against | the carb jet, and putting a cutoff in front of the float would only cause the bowl level to lower with very slight | leaning due to the reduces head pressure. One of these days I'll get to mess around with one of these engines.... | | Thanks Jim... | | |
#24
|
|||
|
|||
![]() "Jose" wrote in message news:s8eTf.6791 I've never heard it expressed quantitatively thus. Could you elaborate? I think what he's referring to is called "head pressure". |
#25
|
|||
|
|||
![]() "C J Southern" wrote in message Not really. For me, the question is do I bother making the trip to the airport, or do I wait for someone else to be the "canary in a cage". I've also got a slightly nervous a passenger to consider...... The crux of the question really is ....... No, the crux of the question is this: why won't you, as putative PIC, just make a decision? Why do you need a committee of people thoroughly unfamiliar with the details to consult with and support you? You don't fly an aircraft, particularly a single-pilot aircraft, by consensus. You're clearly hesitant about the aircraft and don't really want to take it, but you post to the NG in a way that says 'I'm bothered by this craft, but I don't want anyone to think I'm a wuus'. Take it, or don't take it, but make a decision. If there's not enough data to confirm safety, then don't take it. |
#26
|
|||
|
|||
![]() "Jim Macklin" wrote in .....If the float valve was leaking, the fuel level would rise Not likely to happen on a low-wing twin. Maybe a Cessna single. |
#27
|
|||
|
|||
![]()
weight is a function of density, volume does not matter when
pressure is measured in PSI. The density of gasoline changes much? Weight is mainly a function of the quantity of matter present (mass) and the gravitational field it's in. Given liquid gasoline and the earth, volume is a good stand-in for weight. Pressure depends on the height of a column of fluid in a gravitational field. Is that what you meant? Jose -- Nothing takes longer than a shortcut. for Email, make the obvious change in the address. |
#28
|
|||
|
|||
![]()
Who said this was a low-wing twin?
"John Gaquin" wrote in message ... | | "Jim Macklin" wrote in | | .....If the float valve was leaking, the fuel level would | rise | | Not likely to happen on a low-wing twin. Maybe a Cessna single. | | |
#29
|
|||
|
|||
![]()
Gasoline changes density with the blend and it also changes
with temperature. The "standard" 6 pounds per gallon (US) is just an average. Yes, the distance the weight a fluid (including air) acts under gravity determines the pressure. Volume is a measure of space, density is a measure of mass per unit space. -- James H. Macklin ATP,CFI,A&P -- The people think the Constitution protects their rights; But government sees it as an obstacle to be overcome. some support http://www.usdoj.gov/olc/secondamendment2.htm See http://www.fija.org/ more about your rights and duties. "Jose" wrote in message . net... | weight is a function of density, volume does not matter when | pressure is measured in PSI. | | The density of gasoline changes much? Weight is mainly a function of | the quantity of matter present (mass) and the gravitational field it's | in. Given liquid gasoline and the earth, volume is a good stand-in for | weight. | | Pressure depends on the height of a column of fluid in a gravitational | field. Is that what you meant? | | Jose | -- | Nothing takes longer than a shortcut. | for Email, make the obvious change in the address. |
#30
|
|||
|
|||
![]()
"Jim Macklin" wrote in message
news:BBgTf.118099$QW2.115471@dukeread08... Who said this was a low-wing twin? Do you know of a high-wing twin that uses "C172 engines"? (as stated in the original post) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 03:55 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | June 2nd 04 07:17 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | May 1st 04 07:29 PM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | April 5th 04 03:04 PM |