CAD drawing for DG instrument panel...

Before I draw up my own, I'm wondering if anyone out there has a CAD
drawing for a DG instrument panel (non-motorglider, 300, 600, 800S, and
possibly 100/200 panels should all be usable). I want to use an NC
machine to cut a new panel face for my DG-600. If anyone has a drawing
for any panel with correct standard instrument holes (altimeter, in
particular), that would also be helpful...

Thanks,
Marc

Note: remove REMOVE from email address...

Try this one, Marc:
http://www.dg-flugzeugbau.de/Data/instrument-panel.zip

That was easy...........any tips on where to dind a CAD drawinf of a
panel for Ventus C (lift up) ?
Cheers
Mark

Here is a link to M&H and V2C panel.

http://www.mandhsoaring.com/Panels/Panel_2b.pdf

Bob

JS wrote:
Try this one, Marc:
http://www.dg-flugzeugbau.de/Data/instrument-panel.zip


Thanks, I did have that, but I was hoping someone had something that
they had verified was dimensionally accurate...

Marc

Marc Ramsey wrote:
Before I draw up my own, I'm wondering if anyone out there has a CAD
drawing for a DG instrument panel (non-motorglider, 300, 600, 800S, and
possibly 100/200 panels should all be usable). I want to use an NC
machine to cut a new panel face for my DG-600. If anyone has a drawing
for any panel with correct standard instrument holes (altimeter, in
particular), that would also be helpful...

Thanks,
Marc


Marc,
I've got a DG-600 non motor and a buddy of mine & I (more him than me)
cut a panel on his CNC mill last season. We used I think .090
aluminum . We used the old fiberglass panel for a templett, cut the
outline, used a hand brake to bend the lower mounting flange, the upper
and side flanges to secure the pod cover. If there is enough interest
he's willing to cut more of these panels and can cut to your specs. I
had him cut 3 large holes, 80mm in the top row and 2 rows of 57mm
below plus 4 circuit breaker holes and 1 master switch hole .
you can contact me at r.barry at sbcglobal dot net.