![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#121
|
|||
|
|||
![]()
Interesting thread. I'm pretty new having just done my solo cross country,
but I do have several entrys into Honolulu Class B space. I find its always an adventure coming into Honolulu. We do normal 45 degree entries into down wind, direct to base and even direct final, with frequent directions from ATC to circle at various points enroute to delay for other traffic coming in. We go from on final to 04L to "make that 04R". I've turned final and then been told to make a 360 right where I was at -- all in all I think its fair to say you need to be prepared for the unexpected when coming into and when in the pattern.... But, ain't it fun :-) "Wade Hasbrouck" wrote in message ... "Mxsmanic" wrote in message ... Wade Hasbrouck writes: No... It means a "0 degreee entry to base" from where your at... i.e. your position is sufficent that you could fly perpendicular to the runway from your position and make a direct/0 degree entry to the base leg. OK. If I'm not aligned with the base leg, what would the controller request of me, and how would I enter it? (I don't think the sim ATC is that sophisticated, but I'd still like to know.) Enter the base leg as however you see appropriate, if a pilot is unsure of or confused about what they are to do, the rule is "ask for clarification", but you don't have anyone to ask in flight sim. Flight Sim gives you this instruction before entering the aiport's airspace, so you should have plenty of space and time, to get aligned for the base leg. There is reason why it is "pilot in command" and not "Air Traffic Controller in Command". Problem with Flight Sim, is they are going to tell you "Enter leg of pattern" on intial contact, which doesn't always happen in real life... For instance when approaching Boeing Field from the East, and calling them from over downtown Bellevue before entering their airspace... They may tell you one of two things (landing to the south). Usually they will tell you "Report Seward Park" or they will tell you "enter Base for 13L" If it is the first, which it is 9 out 10 times, you head for Seward Park, and once over Seward Park you give them a call and they will usually say "Cleared to land runway 13L", which then you execute turn that is somewhere between 90 degrees and 135 degrees to enter the downwind, or the may tell you "Enter base for 13L", which doesn't happen very offten. Will controllers ever ask you to enter a pattern in a way that requires a sharp turn? For example if your heading is 240 and your landing runway is 24, would a controller ever ask you to enter the downwind leg of the pattern, which (if I understand correctly) would require swinging well out to the left of RWY24 and making a 180° turn? If so, what would be the reason for it? If the controller has any sort of brain you should get a "straight-in for Runway 24" Happens all the time when going into Boeing Field when approaching from the south and they are landing to the north (Rwy 31L and 31R). When I initially took lessons on a solo scholarship through CAP, my instructor and I were out doing touch and goes on Rwy 34 at GTF, on about the third one, mid-field, the controller told us "Cessna xxxx, Cleared Touch and Go, Runway 16.", which I looked at my instructor and asked "You mean we gotta turn around and go to the other end???", which he told to hold on a second, and about 3 seconds later, the controller came back and said "Sorry, Cessna xxxx, cleared touch and go, Runway 34.", which afterward my instructor said "Student controller..." and smiled. Also, are the directions of patterns (left or right) always assigned to avoid crossing the take-off and landing paths of parallel runways? And can I assume that a controller will not ask me to enter a pattern in a situation where I'd have to cross the approach and landing paths of a parallel runway in use? What happens with the center runway, when there are three runways? How does the pattern work? (Three parallel runways seems to be uncommon, though, especially active runways.) Would assume the Center runway is pretty much always a "straight-in", don't know of any non-towered airports that have three parallel runways. Never landed at an airport with three parallel runways so, I don't know. |
#122
|
|||
|
|||
![]()
On Sun, 15 Oct 2006 17:57:12 -0400, Ron Natalie
wrote: Dan wrote: Right.. for example at OSH where they are landing 3 planes at a time on the same runway. Oshkosh gets a special exemption to allow that. Normally, there are stricter rules that the controllers must follow. They have to plan (with little exception) that one aircraft can not touch down until the other is clear. Going into OSH about a week before the fly-in one year there were a pair of us flying loose formation turning final. One was a Cozy and the other my Deb. A tail dragger had landed and only partially turned off at the first taxiway. The Cozy (canard) didn't have room to land. I told the tower I had plenty of room. There was a pause followed by ahhh OK. I had to apply power to get up to the tail dragger who was still setting there talking to the ground crew. I started to go around and they were gesturing for him to hurry up and get out of the way. After all he could have stopped clear of the runway as he had a good 100 feet plus to the west parallel taxiway for 36. As usual I had trouble convincing them the Deb went in the classic camping area even with my 1959 model sign.:-)) Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com |
#123
|
|||
|
|||
![]()
On Sun, 15 Oct 2006 22:56:25 -0500, "Jim Macklin"
wrote: With an operating tower, your traffic pattern can be whatever you and the tower can agree on at the moment. Right traffic, left traffic, straight in, are all OK if approved. You can ask for a take-off on 1R and do a left turn and get the option on 17R, next time around, teardrop and land on 31 and then do an cross over at mid-field to a left downwind full stop on 19L because it a closer taxi. I've this type of creative traffic pattern at Wichita, Tulsa Int'l and also fit into arriving airplane traffic while 3BS is uncontrolled. The RNAV/GPS for both 06 and 24 start so far out they are straight in from outside the airport area. The VOR-A comes in at an angle at half pattern altitude crossing all runways at about 45 degrees. We have 18/36 and 06/24 while the approach is a circle to land from a heading of 137 degrees at 500 AGL. That's where you really need a safety pilot with their head on a swivel and I still take the foggles off at least 3 miles out. doing multiengine training doing steep turns and close traffic to avoid the final approach to the active runways. Ask and you shall receive. But see and avoid and right of way still applies. I've even had the ILS 28 when traffic was departing 10 at TVC. It was see and avoid as well as advisories from the tower. I gotta admit that with a 20 knot tail wind maintaining the GS was a challenge. :-)) Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com |
#124
|
|||
|
|||
![]()
"A Lieberma" wrote in message
. 18... and you get no sense of accomplishment sitting in your lazy boy chair either AFTER flying a REAL plane. After all, you are only SIMULATING what is experienced better in a REAL plane. So, does that mean that after sim-flying, the simmer can only drink a near-beer? |
#125
|
|||
|
|||
![]()
"Grumman-581" wrote in
: "A Lieberma" wrote in message So, does that mean that after sim-flying, the simmer can only drink a near-beer? More like a Hi C fruit drink *big evil grin* or a Shirley Temple. Allen |
Thread Tools | |
Display Modes | |
|
|