![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I am looking for an alternate source for the rudder cables. Blanik
will make them at a cost of $1,400.00 for a set, plus the lead time. Has any one gotten a STC or Field Approval for a different cable? If not I will proceed with trying to get a Field Approval for mine. Also does any one have the same (STC or Field Approval) for replacing the 350x135 tire and tube. Once again if not I will proceed with mine. Have a lofty day, RKW |
#2
|
|||
|
|||
![]() "RKW" wrote in message ... I am looking for an alternate source for the rudder cables. Blanik will make them at a cost of $1,400.00 for a set, plus the lead time. Has any one gotten a STC or Field Approval for a different cable? If not I will proceed with trying to get a Field Approval for mine. Also does any one have the same (STC or Field Approval) for replacing the 350x135 tire and tube. Once again if not I will proceed with mine. Have a lofty day, RKW If you have not looked at them yet [or removed them for that matter] you are in for a surprise - they will not be what you might expect and have a custom end piece swaged right onto the cable. They are also a real joy to remove. After some preliminary discussion with McFarlane we sent our cables to them to have alternatives made up along with all the necessary paperwork and documentation, but after seeing them they were not able to help us. I believe that the main problem was the bearing in the rudder attachment fitting. At any rate, we have gone back to Plan A and ordered them through Blanik. Bruce |
#3
|
|||
|
|||
![]()
I have the replacement 350x135 tires here
http://www.wingsandwheels.com/page33.htm tim "RKW" wrote in message ... I am looking for an alternate source for the rudder cables. Blanik will make them at a cost of $1,400.00 for a set, plus the lead time. Has any one gotten a STC or Field Approval for a different cable? If not I will proceed with trying to get a Field Approval for mine. Also does any one have the same (STC or Field Approval) for replacing the 350x135 tire and tube. Once again if not I will proceed with mine. Have a lofty day, RKW __________ Information from ESET NOD32 Antivirus, version of virus signature database 5438 (20100909) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com __________ Information from ESET NOD32 Antivirus, version of virus signature database 5438 (20100909) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pretensioning cables | Gig 601Xl Builder | Home Built | 18 | December 1st 08 10:22 AM |
FS: Piper Booster cables | Ottprivatesale | Owning | 0 | July 11th 06 04:36 AM |
unsticking cables | dlevy | Owning | 12 | January 8th 06 09:39 AM |
MiG-29 cables | alcatraz | Military Aviation | 0 | March 1st 04 10:01 PM |
Control cables for gliders | mike maskell | Soaring | 10 | January 1st 04 05:08 AM |