|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 26th 12, 12:13 AM
posted to rec.aviation.soaring
|
|||
|
|||
Komet Trailer Parts
I am looking for a US source for hub seals for my 1981 Komet
trailer. Any guidance would be appreciated. Dan Mockler 
|
|
#2
April 26th 12, 11:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Komet Trailer Parts
On Wednesday, April 25, 2012 4:13:44 PM UTC-7, Dan Mockler wrote:
I am looking for a US source for hub seals for my 1981 Komet trailer. Any guidance would be appreciated. Dan Mockler Dan, Try these folks, www.applied.com I know that they have access to almost everything made. If not then let me know and I will see what I can do. BIll
|
|
#3
April 29th 12, 02:47 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Komet Trailer Parts
On Apr 26, 6:40*pm, wrote:
On Wednesday, April 25, 2012 4:13:44 PM UTC-7, Dan Mockler wrote: I am looking for a US source for hub seals for my 1981 Komet trailer. Any guidance would be appreciated. Dan Mockler Dan, Try these folks,www.applied.com I know that they have access to almost everything made. If not then let me know and I will see what I can do. BIll Any luck with finding a source for Komet parts in the US? I have an older (early 1980's?) Komet and have been having problems with the ramp/jack. I did a quick search throught the website mentioned above but didn't find anything. Thanks
|
|
#4
May 1st 12, 05:31 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Komet Trailer Parts
For a ramp jack you might look at an auto junk yard for a scissor jack. For
stability you should use two jacks ganged together. A friend told me long ago to be sure the jacks are the same part number to assure the same lift to crank ratio; otherwise, as you jack up the ramp, it will tilt. "RS" wrote in message ... On Apr 26, 6:40 pm, wrote: On Wednesday, April 25, 2012 4:13:44 PM UTC-7, Dan Mockler wrote: I am looking for a US source for hub seals for my 1981 Komet trailer. Any guidance would be appreciated. Dan Mockler Dan, Try these folks,www.applied.com I know that they have access to almost everything made. If not then let me know and I will see what I can do. BIll Any luck with finding a source for Komet parts in the US? I have an older (early 1980's?) Komet and have been having problems with the ramp/jack. I did a quick search throught the website mentioned above but didn't find anything. Thanks
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Komet Trailer Suspension Parts | Randy[_2_] | Soaring | 4 | December 15th 10 04:04 AM |
| Trailer tires for old (1981) Komet Trailer | [email protected] | Soaring | 3 | May 13th 09 10:24 PM |
| Old Komet Trailer | thermalrider | Soaring | 7 | October 11th 08 04:13 PM |
| KOMET Trailer Cradle | [email protected] | Soaring | 3 | September 27th 04 04:33 AM |
| Komet trailer strut | John Shelton | Soaring | 5 | November 15th 03 05:04 PM |
Linear Mode
