Removing oxidation from Cobra trailer trim rubber and plastic fenders

I have an older Cobra with rubber trim strip (bottom edge of trailer top),
originally nice shiny red, now a bit dark and dull.

Anybody have a proven technique for getting the color back?

Similar for fenders?

Thanks,
Best Regards, Dave

Hi Dave:
On my Nimbus I masked the trim and hit it with Krylon brand "Fusion" spray paint. It bonds to plastic well. Also - Spindleberger sells replacement trim if you like.
Roy

On Sunday, September 24, 2017 at 11:43:52 AM UTC-6, Dave Nadler wrote:
I have an older Cobra with rubber trim strip (bottom edge of trailer top),
originally nice shiny red, now a bit dark and dull.

Anybody have a proven technique for getting the color back?

Similar for fenders?

Thanks,
Best Regards, Dave

Remove and replace with new! Also known as how to end bore doom during winter months.

Best. #711.
Best.

Spindleberger catalog calls it "protection stripe"

On Sunday, September 24, 2017 at 12:17:05 PM UTC-6, Roy B. wrote:
Spindleberger catalog calls it "protection stripe"

And Vendors here in USA sell this.

Best. #711.

On Sunday, September 24, 2017 at 10:43:52 AM UTC-7, Dave Nadler wrote:
I have an older Cobra with rubber trim strip (bottom edge of trailer top),
originally nice shiny red, now a bit dark and dull.

Anybody have a proven technique for getting the color back?

Similar for fenders?

Thanks,
Best Regards, Dave


Use boat stuff avail at a place like West Marine. Suggest Inflatable Boat Cleaner

Jim

At 17:43 24 September 2017, Dave Nadler wrote:
I have an older Cobra with rubber trim strip (bottom edge of trailer
top),
originally nice shiny red, now a bit dark and dull.

Anybody have a proven technique for getting the color back?

Similar for fenders?

Thanks,
Best Regards, Dave

I painted mine when we re-painted the trailer.

Dave

If you replace the trim use blue not red

I did what Roy did, knock off the crud with wire brush and 80 grit sandpaper, then mask and shoot with rattle-can, changed to blue. I used 2" tape on top and a 3 foot piece of cardboard below the lip.......spraying 2 foot at a time with the can aimed down 45 degrees. I'm buffing the glass top now........good winter projects.
JJ

Curious - why blue instead of red?Â* Something to do with solar radiation?

On 9/25/2017 7:40 AM, wrote:
I did what Roy did, knock off the crud with wire brush and 80 grit sandpaper, then mask and shoot with rattle-can, changed to blue. I used 2" tape on top and a 3 foot piece of cardboard below the lip.......spraying 2 foot at a time with the can aimed down 45 degrees. I'm buffing the glass top now.......good winter projects.
JJ

--
Dan, 5J