|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 12th 18, 02:55 PM
posted to rec.aviation.soaring
|
|||
|
|||
CAD drawing DG-100/101 instrument panel
Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere.
Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now. Any help is appreciated! 
|
|
#2
October 12th 18, 03:42 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
CAD drawing DG-100/101 instrument panel
On Friday, October 12, 2018 at 7:55:16 AM UTC-6, Senna Van den Bosch wrote:
Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere. Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now. Any help is appreciated! I have a CAD drawing for a DG-600. I do not know if it is the same as a -100/101.
|
|
#3
October 12th 18, 04:23 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
CAD drawing DG-100/101 instrument panel
On Friday, October 12, 2018 at 9:55:16 AM UTC-4, Senna Van den Bosch wrote:
Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere. Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now. Any help is appreciated! Hi Senna, try here under 'Bretter': http://martinkopplow.de/Instrumente/...haus/Home.html Good luck, Uli 'AS'
|
|
#4
October 12th 18, 10:47 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
CAD drawing DG-100/101 instrument panel
Trace the existing panel on drawing paper. Scan it, import it cad. Trace over the top of it. Scale it to size.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cad drawing for ASW27 or ASG29 instrument panel | Larry Goddard | Soaring | 16 | December 30th 18 07:19 PM |
| ASW 19 Instrument Panel CAD Drawing | Jonathan Phillips | Soaring | 11 | July 18th 18 10:56 PM |
| ASW 19 instrument panel | Charles Longley | Soaring | 14 | November 1st 17 07:47 AM |
| Ka6E Instrument panel drawing | XN | Soaring | 0 | July 27th 12 06:34 PM |
| CAD drawing for DG instrument panel... | Marc Ramsey | Soaring | 5 | April 7th 06 07:12 AM |
Linear Mode
