![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
So the needle fell off my 302 yesterday. Noticed it on the ground, but the landing wasn't that firm.
Anyway, I thought I could get by short term without it, as I use it to feed the Clearnav, and have a Butterfly as well. But a very wise man suggested that the 302 hunts for the needle position on start up for calibration, and might not work without the needle. I tried it, and he was correct. Could it be as simple as opening up the case and gluing the needle back on with a dab of |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
No mention of this in here yet? I nearly fell over when I read this... | Jess Lurkin[_4_] | Aviation Photos | 8 | October 20th 12 10:20 AM |
"Passenger Fell Out"??? | Jay Honeck | Piloting | 8 | October 12th 04 02:44 PM |
zzz BBob fell asleep at the wheel again zzz was Need Microbalancer | B25flyer | Home Built | 24 | August 29th 03 12:04 PM |