![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]() SuperLube is super. Nothing comes close. Thanks You know I actually had some in the assembly box, but it felt too thin so I used the good old Lucas White. The SuperLube didn't pass the feels right test for grease that has served me well for wheel bearings for decades. Reading today I learned there are two grease film tests. Timken OK (ASTM 2509) for rolling bearings. Four Ball (ASTM 2596) for sliding things like ball joints. Super lube is a bit behind for rolling, but way ahead for sliding. Lucus Extreme Pressure Synthetic Grease appears even better? https://lucasoil.com/pdf/TDS_Extreme...lve_Grease.pdf Today is clean out the white grease, inspect and put in the fancy stuff. I continue to be amazed at the new things to learn with gliders. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rigging grease recommendations for long-term-rigged gliders | Jim Hogue | Soaring | 19 | February 4th 20 03:29 PM |
Youth soaring program looking for wing wheel for large-chord wing | Jay[_2_] | Soaring | 1 | September 17th 14 02:44 AM |
Grease recommendation | Bastoune | Soaring | 20 | April 2nd 10 08:57 PM |
Books on Military Rotary Wing to Civilian Fixed Wing Transition? | Greg Copeland | Piloting | 5 | May 2nd 07 03:23 AM |
2.4 hours - no oil/grease on prop/windshield | Jay Honeck | Owning | 8 | September 30th 06 01:25 PM |