|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 14th 21, 01:40 AM
posted to rec.aviation.soaring
|
|||
|
|||
SN10 Question
After performing a leak check on my TE system, my SN10 now sounds a continuous tone after power up. (On the ground, haven’t tried in the air) It is not in speed to fly mode but is in vario mode. Prior to this it was always “silent” after start up. Have I possibly damaged an internal sensor that requires sending it in to Ilec? I have updated it to latest version 2.47.
John U. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SN10 | K | Soaring | 0 | September 15th 12 02:15 AM |
| SN10 Startup Question | YourNameHere | Soaring | 2 | October 17th 11 01:56 PM |
| SN10 USB question | Tuno | Soaring | 2 | August 22nd 11 02:33 PM |
| Ilec SN10 question | Dan Goldman | Soaring | 0 | February 20th 11 11:07 PM |
| Ilec SN10 question | John Ferguson | Soaring | 3 | May 29th 07 05:11 AM |
Threaded Mode