|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 4th 03, 04:28 AM
|
|||
|
|||
Transponder Problem
The third digit on my formerly bullet-proof Narco AT-50 transponder has
suddenly started displaying incorrectly for ATC. Specifically, it seems to be showing as a "4" on their screens, regardless of what we dial it to in the plane. Thus, instead of squawking "1200" when we're VFR, we're squawking "1240"... What could cause this? Any recommendations on repair versus replacement? Thanks! -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 04:29 PM |
| A problem in the Military ? | Nick Jade | Military Aviation | 54 | March 15th 04 07:59 PM |
| Fixing the Transponder with Duct Tape and Aluminum Foil | Ron Wanttaja | Home Built | 45 | March 14th 04 12:18 AM |
| Garmin fixes moving waypoint problem -- almost | Jon Woellhaf | Instrument Flight Rules | 6 | November 28th 03 05:29 PM |
| Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |
Threaded Mode