![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Based on advice from a column I read on AVWEB by John Deakin, I had my
Tach checked since it was in the shop anyay. I was surprised to find out that it was reading 150 RPM lower than the true RPM. That seems pretty bad. I said, OK, no problem, just adjust it. No dice. I was informed that it was a "mechanical type" tachometer and that there was no adjustment possible. I really do not care for the idea of having to remember to add 150 to the tach reading everytime I do my settings. Is there really no way to adjust these things? If not, is there an alternative? I read an add for a digital tach called a P-1000 by Horizon Instruments. Seems really good, but at $510, it seemed a bit steep to avoid doing a little math everytime I set my RPMs. Are there alternative replacement tachs that are less expensive that folks here have been happy with? -Sami N2057M, Piper Turbo Arrow III |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mechanical tach failure? | Rich S. | Home Built | 25 | November 6th 04 03:30 PM |
Tach Vs. Hobbs Time | John Roncallo | Owning | 33 | January 7th 04 12:42 AM |
Need new PA28 tach | Michael Isaksen | Owning | 2 | October 2nd 03 03:27 PM |
Tach 100rpm low | Ben Smith | Owning | 3 | July 7th 03 03:41 PM |