![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Not simple. Questions abound: depending on type engine, type induction,
whether turbocharged, field altitude, density altitude, formula gasoline (Some people love autogas), and much more. For example if your plugs aren't gapped correctly you're going to have a serious problem sooner or later. I saw an O-235's plugs recently and couldn't believe the lead deposits and fouling. Don't know if they were gapped properly but the spaces inside the plugs between the ceramic and the inside diameter of the plugs were filled with hard gray deposits. Yesterday I talked to an owner of a fleet of busy airplanes used for rental and instruction. His airplanes, which run from 152's to 172's on up to a fast and complex Beechcraft, are generally flown with the mixture too rich. He said that a few years ago he and a burly passenger took off in a Cessna 150 with about 100 hours since engine rebuild on the O-200. An exhaust valve stuck open, and they barely had enough altitude to make it back to the field. He's been using Mr. Marvel and Mr. Mystery and no problems since, "knock on wood." An ounce or two in the gas, and only a capful or two in the sump. He is also an A&P with inspection authorization and a high-time pilot who drove airliners. He says burning carbon off by leaning and revving the engine on the ground is not a good practice, but he does cheat occasionally. Only for maybe 30 seconds or less. If that doesn't clear it, back to the hangar he taxis. I have been using MMO since the 80's. It's legal in an experimental, not in a certified aircraft, however. Alcor TCP is legal for certificated airplanes. I wouldn't run even an O-200 w/o monitoring CHT and EGT and adding something to clean the plugs and combustion chambers. I'm building up an IO-360 for an experimental and planning to go FADEC. Oh, and the old timers (usually the mechanics who also fly and maintain their own aircraft) can tell you that a tiny obstruction under the cowl or a piece of bad or loose baffling can give you a fried cylinder. |
Thread Tools | |
Display Modes | |
|
|