|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
March 18th 04, 03:49 AM
|
|||
|
|||
I cannot speak to your airframe. When we did the calcs on Voyager, we figured we added roughly half a knot for each antenna we put inside the fuselage. I'd probably guess about the same for you. Worth the bother? Perhaps. Surely makes a cleaner looking airplane, even WITH the scab patches over the old antenna holes (painted to match, of course). Jim "Jay Honeck" shared these priceless pearls of wisdom: -Is it worth the bother? Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing water repelent from fiberglass lay-up? | Roger | Home Built | 2 | December 2nd 04 11:15 PM |
| Do ADF antennas need replacing if changing the receiver? | [email protected] | Owning | 5 | December 11th 03 10:13 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |
| Hidden Antennas | Dick Goff | Home Built | 2 | August 20th 03 05:23 PM |
| F-14 squadrons removing refueling cover plate? | dave999 | Military Aviation | 7 | August 6th 03 09:45 AM |
Threaded Mode