|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
October 31st 04, 05:07 PM
|
|||
|
|||
I did the job this morning. It took two hours to get the starter out.
You must remove the prop, front of cowl and unbolt the oil cooler to get at the four 1/2 inch nuts holding it on. Not a bad job but a little tight. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starter Questions | Aaron Coolidge | Owning | 4 | June 30th 04 02:52 PM |
| Stuck starter solenoid? | Paul Lee | Home Built | 4 | April 16th 04 02:58 PM |
| LIghtweight starter recommendations for PA24-250? | Chris Kennedy | Owning | 4 | April 8th 04 12:01 AM |
| Starter selection -- seeking input | [email protected] | Owning | 3 | April 5th 04 12:43 AM |
| Sticking Starter | Wayne | Owning | 5 | September 2nd 03 07:26 PM |
Threaded Mode