|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
February 15th 04, 08:59 PM
|
|||
|
|||
In article ,
"Bill Daniels" wrote: "rip" wrote in message news  File smooth, and then use an oxy-hydrogen torch with a soft flame. This will give an instant flame polished edge. See your local plastic supplier if you're not equipped to do this solo. Rip Right on, Rip. This is the slickest, easiest, most professional way to get clean, clear edges on Lexan and Plexiglas. If you are really quick with the torch, you can de-burr drilled holes this way too. And -- if you are NOT quick with the torch? It is safer to use the filing/ sanding/polishing technique. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| best cutting fluid/oil/paste 2004..... theory and practice? | B2431 | Home Built | 1 | January 20th 04 06:27 PM |
| Cutting sheet steel | Ernest Christley | Home Built | 28 | November 28th 03 06:58 PM |
| air drill question | Ded Dog | Home Built | 24 | November 24th 03 10:43 PM |
| blue foam & cutting it | Richard Riley | Home Built | 6 | November 24th 03 01:53 PM |
| canopy breaking tool? | Russell Duffy | Home Built | 33 | September 30th 03 11:39 PM |
Threaded Mode