|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
November 27th 04, 09:32 PM
|
|||
|
|||
JB wrote: Well there's my answer... no -R on the serial, it's a factory o/h then. I'm still thinking about what to do with the jugs; I know the prices of new ones have come down quite a bit, with jugs from ECI and Superior going for around $900-1100 or so, but still... if these are first run cylinders with 1660 hrs, and the engine was running great when removed; there's probably lotsa life left in 'em after an overhaul, and I'd get to save several hundred bucks per jug. According to their ads, Lycoming replaces the cylinders with new when they overhaul an engine. George Patterson 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Compression loss on cylinder when rings line up Truth of fiction? | test it | Home Built | 10 | May 11th 04 08:11 PM |
| #5 cylinder not firing | David R. | Owning | 13 | February 27th 04 12:41 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
| 'Hot' cylinder after overhaul? | Tony Cox | Owning | 8 | August 10th 03 07:25 PM |
Threaded Mode