|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 19th 04, 03:25 PM
|
|||
|
|||
3 blade prop position on 6cyl engine.
Whats the best 3 blade prop position on a 6 Cyl Franklin?
The Ivo prop instructions only give an example for a 4 cyl IO-360 to place one blade on TDC position. That's where I placed it for the 6 cyl Franklin for now. ---------------------------------------------------- Paul Lee, SQ2000 canard project: www.abri.com/sq2000 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Car engine FAA certified for airplane use | Cy Galley | Home Built | 10 | February 6th 04 03:03 PM |
| Pitch and Diameter of 3 blade prop for IO-360 200HP | Bart D. Hull | Home Built | 1 | December 11th 03 11:42 PM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
| Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |
| Gasflow of VW engine | Veeduber | Home Built | 4 | July 14th 03 08:06 AM |
Threaded Mode