|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
February 27th 04, 09:51 AM
|
|||
|
|||
"Veeduber" wrote Dear Del, Consider a couple of different lines :-) The point of contact with the metal is seldom more than half an inch wide and usually less. The only thickness consideration in the leaf is to accommodate the fasteners. The leaf is a LEVER. You should be more concered with its depth; 2x10 or 2x12... something along those lines. -R.S.Hoover ???????????????????????????? Perhaps I missed it. Where are the pictures? -- Jim in NC --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.594 / Virus Database: 377 - Release Date: 2/24/2004 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |
| ?s about building a gyrocopter | John Normile | Home Built | 2 | September 14th 03 02:01 AM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |
Threaded Mode